Technical Support (707) 544-4761
5
www.HURST-SHIFTERS.com
14. Remove the four (4) 18mm bolts securing the
transmission to the frame. Lower the rear of the
transmission. Support the rear with a transmission
stand if you have the vehicle supported with a lift;
support the rear with a floor jack if you have the
vehicle supported with jack stands.
Tools: Breaker Bar, 18mm Socket, Ratchet, Extension
15. Remove the three (3) 15mm bolts securing the
crossmember to the transmission.
Tools: Breaker Bar, 15mm Socket, Ratchet
16. Remove the three (3) 18mm bolts securing the
front end of the driveshaft to the transmission.
IMPORTANT:
Make an alignment mark between the
Flex Coupling and the transmission flange. You must
re-install the driveshaft in the same position as it was
removed.
Tools: 18mm Socket, Ratchet
17. Remove the center bearing bolts.
Tools: 13mm Socket, Ratchet
