Technical Support (707) 544-4761
4
www.HURST-SHIFTERS.com
10. Remove the retaining screw and then remove the
factory reverse lockout sleeve and rubber boot. The
retaining screw and rubber boot will be reused.
Tool: T20 Torx Driver
11. Lift the vehicle. Support the vehicle with
Jackstands if working with a floor jack.
12. Although this step is not required it makes for ease
of removal and installation. Support the mid-section of
the exhaust. Loosen the nuts at the two exhaust
connections just behind the transmission. Move the
system to the rear and let the system hang in place.
Tools: 15mm socket
13. Support the transmission.
Tools: transmission stand or floor jack
