Technical Support (707) 544-4761
3
www.HURST-SHIFTERS.com
6. Unplug the harness from the console and set the
console aside.
7. Remove the shift boot. There are three clips holding
the boot to the reverse lock out sleeve, use a screw
driver to pry one clip at a time while pulling up on the
boot. Set the boot aside for reinstallation later.
8. Once the rubber boot is removed continue by
removing the plastic ring and the rubber O-ring. The
plastic ring and rubber O-ring will be re-used .
9. Remove the
spring retaining roll pin and the spring.
The spring will be reused.
Tools: 4mm Punch, Hammer
