INSTALLATION
6
Mount the Installation Brackets — Outside Mount
■
■
Center the headrail over the window opening at the desired height. Use a pencil to lightly
mark each end of the headrail.
■
➤
Alternatively, measure the width of the headrail and use that width to mark the headrail
end points over the window opening.
■
■
Mark 2" from each of the headrail end marks for bracket location.
■
➤
If more than two installation brackets came with your order, space additional bracket(s)
between the two end brackets and mark their location. Mount into wood whenever
possible.
■
➤
For PowerView
™
shadings with battery wand, allow a minimum of 17" between bracket
centerlines for the battery wand.
■
■
Use pliers to break off both the top and bottom tabs from the
installation brackets.
■
■
Center the installation brackets on your marks and mark the
location of the screw holes.
■
➤
A minimum 1
1
/
8
" flat vertical height is required to mount
the installation brackets.
■
➤
Position the top of the installation brackets at the desired
height of the shading. The brackets must be level and aligned.
CAUTION:
The rear of the blocks/brackets must be flush against
a flat mounting surface. Do not mount brackets on curved molding.
IMPORTANT:
Additional clearance is required for PowerView shadings with battery wand.
See “Additional Clearance with Spacer Blocks” on page 7.
■
■
Use a
3
/
32
" drill bit to drill holes for the mounting screws.
CAUTION:
Use drywall anchors when mounting into drywall.
■
■
If no additional clearance is required, attach the installation brackets
directly to the mounting surface using the screws provided.
IMPORTANT:
The front edges of the installation brackets must be
level and aligned to each other.
Window Opening
2"
2"
Headrail End Mark
Headrail End Mark
Top
Tab
Bottom
Tab
