OPERATION
17
Resetting the Shading (If Necessary)
Basic Reset
The basic reset is used to reset the shading’s travel limits.
1. Press and hold the manual control button for 6 seconds. The shading will move slightly.
2. Release the manual control button. The shading will raise to its fully open position to set the
upper travel limit, then lower to the fully closed position with vanes open to set the lower
travel limit. The shading will move slightly one more time to indicate that the travel limits have
been reset.
Resetting Shading Programming
This reset erases all shading programming from memory, including group assignments,
preventing any input device from operating the shading. Its primary use is during installation to
correct group and network assignments. This reset does not affect travel limits.
1. Press and hold the manual control button for 12 seconds. The shading will move slightly after
6 seconds, then again after 12 seconds. Release the button.
2. Refer to “Joining a Shading to a Group” on page 15 to program the shading to a group.
