HunterDouglas Pirouette EasyRise, Установка Эксплуатация Уход

Страница: 15 / 24

OPERATION
13
UltraGlide
®
Shadings
To Lower the Shading
■ ■
Pull the wand straight out from the fabric at an angle greater than 25 degrees. The clutch
will click and the fabric will proceed with a controlled descent.
■ ■
To stop the shading in any position, simply pull the wand straight down.
IMPORTANT: Avoid pulling the wand in the non-operable zone. This is the area between
the angle for lowering the shading and the straight down position for raising the shading.
Refer to the illustration below.
To Open the Vanes
■ ■
After lowering the shading completely, continue to pull on the wand at an angle greater
than 25 degrees, until the vanes are fully open.
To Close the Vanes and Raise the Shading
■ ■
Hold the wand close to the fabric and pull straight down.
■ ■
Pump the wand down using short strokes to gradually raise the shading.
CAUTION: To avoid damage to the shading or personal injury, do not release the wand
until it is fully retracted. To avoid breaking the wand, do not use long strokes (over 42") or
apply excessive force on the wand while pulling it.
Two-On-One Headrail UltraGlide Shadings
■ ■
Two-On-One Headrail shadings have two wands. The right wand operates the right
shading and the left wand operates the left shading.
Non-
Operable
Zone
To Lower Shading To Open Vanes
To Close Vanes
and Raise Shading