HunterDouglas Cadence Soft Vertical Blinds, Установка Эксплуатация Уход

Страница: 16 / 23

INSTALLATION
14
Cord Adjustment
NOTE: Cord length and/or tension cannot be adjusted for PermaTilt
®
Wand Control System. It is
set in the factory to help ensure that the product meets cord safety standard.
To Reduce Cord Length on a Side Stack Blind — Cord and Chain Only
■
Release the tension on the cord with the cord tensioner; see “Attach the Vertical Cord
Tensioner” on page 13.
■
Place the blind in the open position.
■
Locate the cord knot in the front of the lead carrier.
■
Loosen the adjusting screw until the cord moves.
■
Pull the cord to the desired length.
■
Tie a double knot.
■
Tighten the adjusting screw.
■
Reset the cord tension with the cord tensioner.
■
Test for proper cord tension.
■
Cut the excess cord.
To Reduce Cord Length on Split Stack Blinds
■
Release the tension on the cord with the cord tensioner; see “Attach the Vertical Cord
Tensioner” on page 13.
■
Place the blind in the closed position.
■
Locate the cord ends in the front of the lead carrier.
■
Loosen the adjusting screw.
■
Select the cord knot that adjusts the cord length only; if
carrier movement is observed, select the other cord.
CAUTION: Cutting the wrong cord will cause irreparable damage.
■
Pull the cord to the desired length.
■
Tie a double knot.
■
Tighten the adjusting screw.
■
Reset the tension with the cord tensioner.
■
Test for proper cord tension.
■
Cut the excess cord.
Screw and
Cord Knot
Side Draw
Carriers in
Open Position
Screw
Center Draw
Carriers Closed
Position