8
41473-01 12/6/2001
STEP 5 - WIRING THE FAN
1. Disconnect the power by turning off the circuit break-
ers to the outlet box and associated wall switch loca-
tion.
2. Tilt and hang the assembled fan from the ceiling plate
hooks. Slip two rectangular canopy slots over ceiling
plate hooks as shown in Figures 5a and 5b.
Note: To hang the fan you must tilt the canopy to an
almost vertical position so the canopy slots come
down over the ceiling plate hooks.
3. You can use either one or two wall switches to con-
trol the fan and/or lights separately. Use connection
1 below to
• control the light with a wall switch and the fan
with a chain pull (one wall switch required)
• control the light with a chain pull and the fan with
a wall switch (one wall switch required)
• control the light with one wall switch and the fan
with another (two wall switches required)
Use connection 2 below if there is no separate wall
switch power wire for the light kit.
Figure 5b - Assembled Fan Hanging
from Ceiling Plate Hooks
Ceiling
Plate
Figure 5a - Attaching Slots on Canopy
to Ceiling Plate Hooks
Bare or Green
Approved
Connectors
Power
Wires
In
Ceiling
White
White
Black
Black/White
1
2
Connections:
Black
Wall Switch Wire For
Separate Control of Light Kit
Ceiling
Plate
Outlet Box
2 x 4 Brace
Green Ground
Wire from Hanger
Pipe (standard and
angle mounting only)
Green Ground
Wire from Ceiling
Plate (present with
standard, angle, and
flush mounting)
3 Wires
From Fan
(Note: Wall switch
must be acceptable
as a general-use
switch.)
Connect Blk/Wht Wire from fan
to Wall Switch Wire for separate
control of light, or
Connect Blk/Wht Wire from fan
to Ceiling Black Wire if there
is no separate Wall Switch Wire
for the light kit.
1
2
4. Connect the wires as shown in Figure 5c. To connect
the wires, twist the bare metal leads together. Place
a wire nut over the intertwined length of wire and
twist clockwise until tight as shown.
CAUTION
Be sure no bare wire or wire strands are visible
after making connections.
5. Separate the connected wires by placing the green
and white wires on one side of the outlet box and
the black and the black/white wires on the other side
of the outlet box.
6. Turn the connectors upward. Push the wires gently
into the outlet box.
Figure 5c - Wiring Diagram
