12
41473-01 12/6/2001
INSTALLING INCLUDED INTEGRAL LIGHT FIXTURE
1. In the switch housing assembly you will find a plug
connector: One two-wire connector. The connec-
tor will have a black with white stripe wire and a
white wire.
2. Locate the white wire and the black wire coming from
the light fixture.
3. Connect the upper plug connector from the motor to
the lower plug connector in the light assembly. See
Figure 10a.
Note: Both plug connectors are polarized and will only
fit together one way. Make sure that both connec-
tors are properly aligned before connecting them to-
gether. Incorrect connection could cause improper op-
eration and damage to the product.
4. Place the lower switch housing assembly over the
upper switch housing. Align the side screw holes in
the upper and lower switch housings. Attach the light
to the upper switch housing with three #6-32 hous-
ing assembly screws.
White Wire
from Light
Fixture
Black Wire
from Light
Fixture
Light
Fixture
Figure 10a - Wiring Light Fixture to
Fan
Lower Plug
Connector
Upper Plug
Connector
Upper Switch
Housing
STEP 10 - WIRING THE LIGHT FIXTURE
WARNING
• To avoid possible electrical shock, before install-
ing light fixtures, disconnect power by turning off
the circuit breakers both to the outlet box and to
its associated wall switch location. If you cannot
lock the circuit breakers in the off position, se-
curely fasten a prominent warning device, such
as a tag, to the service panel.
• Connect house wiring to the fan before attach-
ing the light fixture to the fan.
• All wiring must be in accordance with national
and local electrical codes and ANSI/NFPA 70. If
you are unfamiliar with wiring, you should use a
qualified electrician.
INSTALLING INCLUDED SINGLE-GLOBE LIGHT FIXTURE
1. Remove the plug cap from the lower switch housing.
Note: Do not discard the plug cap. You will need this
if you remove the light fixture in the future.
2. Locate the two wires in the lower switch housing
labeled “Connect Light Here” or “For Light Use”.
One will be white, the other black/white. Unscrew
the wire nuts counterclockwise to expose the bare
metal leads.
3. Locate the white wire and the black wire coming from
the light fixture.
4. Thread the two wires from the light fixture through
the center hole in the lower switch housing.
5. Screw the fixture into the lower switch housing.
Thread the lockwasher and nut provided over the
wires. Making sure the light fixture mounting screw
holes are aligned; hold the light fixture and tighten
the nut on the inside of the lower switch housing.
Insert and tighten the two #6-32 sems light fixture
mounting screws.
6. Connect the black wire from the light fixture to the
black/white wire from the lower switch housing. See
Figure 10b.
Connect the white wire from the light fixture to the
white wire from the lower switch housing. See Fig-
ure 10b.
To fasten the wires, twist the two bare leads together.
Place a wire nut over the intertwined length of wire
and twist clockwise until tight.
7. Connect the upper plug connector from the motor
to the lower plug connector in the lower switch hous-
ing assembly. See Figure 10a.
Note: Both plug connectors are polarized and will
only fit together one way. Make sure that both con-
nectors are properly aligned before connecting them
together. Incorrect connection could cause improper
operation and damage to the product.
8. Place the lower switch housing assembly over the
upper switch housing. Align the side screw holes in
the upper and lower switch housings. Attach the
lower switch housing to the upper switch housing
with three #6-32 x 3/8" housing assembly screws.
See Figure 10a.
CAUTION
Be sure no bare wire or wire
strands are visible after making
connections.
