Hunter ICR, Руководство пользователя и инструкции по установке

Страница: 8 / 32

4 5
To utilize the ICR remote control system, your controller
must be equipped with a SmartPort
®
wiring harness. This
wiring harness provides the communication port where the
ICR receiver is attached. The SmartPort
®
can be connected
to Hunter SRC, Pro-C and ICC controllers. A SmartPort
®
wiring harness is provided with your ICR remote system.
The typical SmartPort
®
location is approximately 12" below
the controller. The recommended installation procedure for
this location would be as follows:
SmartPort
®
WIRING HARNESS .......................................................................
INSTALLING THE SmartPort
®
WIRING HARNESS ......................................
1. Install a 1⁄2" female threaded “Tee” in the field wiring
conduit approximately 12" below the controller.
2. Feed the red, white, and blue wires of the SmartPort
®
through the base of the “Tee” and into the controller
wiring compartment as shown in the following figures.
NOTE: The harness may be installed outdoors
by bringing the conduit through an exterior
wall, then installing the appropriate fitting.
NOTE: For installations where the receiver
will be installed permanently on an outside
wall, make certain that the SmartPort
®
is the
version with an o-ring seal.
1
/
2
" Thread
To Controller
Pre-assembled Assembled