Hunter ICR, Руководство пользователя и инструкции по установке

Страница: 12 / 32

8 9
Both the ICR Transmitter and Receiver have an “address”
that they use when communicating. If the addresses do
not match, the Receiver will ignore the transmission. Your
ICR comes from the factory with both the transmitter and
Receiver address set to 0. You may change the address to
any value from 0-127 for added security. Note that if you
change the Transmitter address, the Receiver must “learn”
the new address as described in the “Preparing the Receiver
for Use” section.
To change the Transmitter address:
1. If the unit is OFF (no display), power the Transmitter up
by pressing any of the buttons for at least 1 second then
releasing the button. The Transmitter will illuminate the
active station.
2. Press the Mode button until the word “Address” appears
on the display. The address will be blinking at this point.
If more than 5 seconds go by
without a button being pressed,
the Transmitter will revert back
to displaying the active station.
3. Use the or button to
change the address to any value
between 0 and 127. Then do not
touch any of the buttons for 5 seconds and the display
will stop blinking and return back to the active station.
Your ICR Transmitter comes from the factory with the maxi-
mum number of stations set to 9. This means that when you
use the or buttons to change the station, you may
change it to any number between 1 and 9. However, if you
have controllers with more than 9 stations you will want to
increase the maximum number of stations.
CHANGING THE TRANSMITTER ADDRESS
To change the Maximum Number of Stations:
1. If the unit is OFF (no display), power the Transmitter up
by pressing any of the buttons for at least 1 second then
releasing the button. The Transmitter will illuminate the
active station.
CHANGING THE MAXIMUM NUMBER OF STATIONS
ADDRESS