Hunter ICR, Руководство пользователя и инструкции по установке

Страница: 11 / 32

6 7
The ICR transmitter requires 4 AA alkaline batteries. To
install the batteries. remove the two screws holding the
battery on the back of the transmitter. Drop the batteries
into the battery compartment and replace the door. Your
transmitter is now ready to operate.
with the current Run Time is displayed. (default is 10
minutes) The Run Time will be blinking at this point.
If more than 5 seconds go by
without a button being pressed,
the Transmitter will revert back
to displaying the active station.
3. Use the or buttons to
change the Run Time to any of
the 8 settings ranging from 1 to
30 minutes. Then do not touch any of the buttons for
5 seconds and the display will stop blinking and return
back to the active station.
INSTALLING THE TRANSMITTER BATTERIES ............................................
CHANGING THE RUN TIME ..............................................................................
You have the ability to adjust the amount of time that a sta-
tion will run once it has been turned on by your ICR. This
does not affect the run time programmed into your control-
ler. This adjustment is made at the transmitter as described
below.
To change the Run Time:
1. If the unit is OFF (no display), power the transmitter by
pressing any of the buttons for at least 1 second then
releasing the button. The transmitter will illuminate and
display the active station.
2. Press the Mode button until the words “Run Time” along
RUN TIME