Hunter ICR, Руководство пользователя и инструкции по установке

Страница: 14 / 32

10 11
The ICR system will allow you to remotely turn on and off
any station on your Hunter controller with the press of a
button. Once on, the station will run for the run time you
have designated in the ICR transmitter.
To remotely activate a station or program:
1. Plug your Receiver into an active SmartPort
®
wiring har-
ness (one attached to a powered controller) and wait for
2 beeps indicating the Receiver is ready.
2. If your Transmitter is not on (no display), press any
button for at least 1 second and release. The Transmitter
will display the active station.
3. Use the or buttons to
display the station or program
(A,B, or C) you would like to
start.
4. Momentarily press the “ON”
button to start the station or
program. The Transmitter will
display the word “TRANSMIT” and will flash for about
4 seconds indicating that it is sending the command
to the Receiver. If you are near the Receiver, you will
hear it beep 2 times, indicating that it has received the
command.
5. Press the “OFF” button at any time to turn off the station
or program. The display will again read “TRANSMIT” and
flash, and the Receiver will again beep twice. The ICR
is designed to turn one station on at a time. Therefore,
turning a station on while another is already on will
cause the first station to turn off.
6. If one of the programs (A,B, or C) is selected, all
stations in the selected program will run sequentially for
the run time programmed in the controller.
NOTE: The ICR remote can activate any station
on the controller whether the controller dial
is in the “System Off”, “Run” or “Run/Bypass
Sensor” modes. If a sensor device has been
wired to the controller, the ICR will not
override the sensor for manual operation.
ACTIVATING A STATION WITH THE ICR REMOTE SYSTEM ......................
STATION