Hunter GSP9200 Touch, Руководство по эксплуатации

Страница: 50 / 88

42 BALANCING PROCEDURES
The SmartWeight Touch®/GSP9200 Touch Servo-
Activated Laser automatically locates BDC to aid in fast
adhesive weight positioning.
Figure 164.
The BDC laser locator automatically displays a vivid line
at bottom dead center after a wheel has been spun. The
laser turns off when the wheel is spun again.
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
With the servo enabled, attach the adhesive weight using
the weight amount shown for the left weight plane on the
screen.
TruWeight™ shows the operator exactly how to place the
weights on the wheel. Place them exactly as displayed on
the screen.
Touch the green “START” button with the safety hood in
the raised position.
Figure 165.
Optionally, pressing the next plane weight
amount will rotate the wheel to the next weight
plane.
Close the safety hood to perform a check spin.
Left and right weight plane displays should show “OK”
after the check spin.
If the Split Spoke® feature of hiding weights behind
spokes is to be used, position the Dataset® arm disk in
the center of a spoke and tap the foot pedal.
Figure 162.
Move to the next spoke and repeat. Up to 10 spoke
locations may be entered.
Close safety hood.
Touch the green “START” button if “Hood Autostart” is
disabled.
As the wheel is spinning, the amount(s) of corrective
weight(s) needed will be shown on the screen. This time
can be used to find and prepare the needed weights..
Once weight amounts are shown on the screen,
they can be toggled to display either ounces or
grams by pressing the “oz” or “g” graphic shown
after the weight amount.
Figure 163.
After wheel comes to a complete stop, raise the safety
hood.
If Auto Hood is enabled, the hood will raise
automatically.