20
BALANCING PROCEDURES
Keep the wheel lift carriage in place under the wheel
assembly and close the hood. The lifting assembly will
automatically lower and park the carriage below.
Figure 56.
Figure 57.
Allowing the balancer to park the wheel lift
carriage in place under the wheel assembly
will make the removal and lowering of wheel
assembly easier and quicker.
Lowering the Wheel Assembly
Remove wheel clamp.
Starting with the wheel lift carriage parked under the
wheel assembly; raise the lift control handle “up” to move
the lifting assembly to the wheel assembly.
Figure 58.
Roll the wheel assembly onto the wheel lift carriage.
Figure 53.
Raise the lift control handle “up” to move the lifting
assembly into a position where the wheel assembly can
be installed onto the spindle shaft.
Figure 54.
Slide the tire/wheel assembly onto the spindle and center
on the collet. Verify that the wheel assembly is centered
vertically on the spindle shaft.
TIRE / WHEEL ASSEMBLY
CENTERED VERTICALLY
ON SPINDLE SHAFT
Figure 55.
Lower wheel lift as needed to clamp wheel, but
keep the wheel lift carriage in place under the
wheel assembly.
Clamp wheel onto the spindle shaft.
Содержание GSP9200 Touch
