Hunter Genesis, Руководство по программированию и эксплуатации, Страница: 26 / 43

GENESIS OPERATIONS MANUAL
24
Option #5 - Cycles
You can use this option to set all the stations in a certain Program/start to repeat their cycles. For example, this
option allows you to run a group of stations several times a day to keep a newly seeded area moist.
Select the Program/Start you want to set repeating cycles for. Then, when you select option #5, the display
shows:
P1 T1 Cycles <1>
Number 1 indicates normal programmed operation. You can enter any number up to 9, but be aware that if you
enter a zero, the stations in that Program/start will repeat continuously until stopped by a programmed End time, a
programmed skip day, or a manual OFF.
Press the number key for the number of repetitions you want. In this example, the display shows the
cycle will repeat five times:
P1 T1 Cycles= 5
Completes the option setting. The display shows:
P1 T1 Cycles= 5
Exits the function, restores the time display.
Option #6 - Cycle Delay
This option sets the length of time between repetitions, or cycles, in a cycle Program (see Option #5).
Select the Program and Start you want to set the cycle delay for. Then, when you select option #6, the display
shows:
Cycle Dly <off>
The maximum delay time you can Program is 24 hours.
Press the number keys for the length of time you want between repetitions of the watering
cycle. In this example, the display shows a 30-minute delay from the end of one cycle to
the beginning of another:
Cycle Dly 0:30M
Note: The time mode (M or S) is dependent on the setting of Option #3. To change modes, see Option #3.
Completes the option setting. The display shows:
Cycle Dly= 0:30M