Hunter DDI, Руководство по установке

Страница: 17 / 26

17
INSTALLATION
STEP 5: GUY WIRES
NOTE
Make sure the guy wires do not interfere with cables or other obstructions.
17mm
socket or
wrench
TURNBUCKLE
SET SCREW
2.5mm
Allen
• Attach guy wire to building structure while maintaining a 45° angle between
the ceiling and the guy wire.
• Do not wrap guy wires around the building structure. The guys wires could fray
if in contact with the building structure.
A
Attach beam
clamps to
structure. Clip
15’ guy wire
end to beam
clamp.
B
Feed one end
of the 15’ guy
wire through
the Gripple.
C
Clip end of
the 2’ guy
wire to the
eyebolt of the
turnbuckle.
D
Feed the
opposite end of
the 2’ guy wire
through the
same Gripple as
the 15’ guywire
from step B.
F
Tighten bolts on
Gripples, and
then tighten the
set screws on the
turnbuckles.
E
Feed guy wires through disc to hold in place
during turnbuckle installation. Pull excess cable
until guy wire is taut. Place level against the
downrod and tighten the turnbuckles by hand
in a crisscross pattern, periodically checking to
ensure the downrod is plumb and the fan is
level.
A
C
E F G
D
B