Hunter DDI, Руководство по установке

Страница: 5 / 26

5
To prevent serious injury or death, ALWAYS attach the Retention Cable to the fan motor and secure to the building structure on
EVERY fan.
The Retention Cable, if installed per Hunter Industrial specifications, can limit the distance the fan could fall in the unlikely event of
mounting system failure. Failure to install and to secure the retention cable will void your warranty.
Always use Personal Protective Equipment
You should always wear Personal Protective Equipment, such as a Hard Hat, Safety Glasses, and a Fall Harness when installing industrial
fans.
Service
If the fan does not operate properly using the procedures in this manual, remove all power to the unit and contact our Technical
Department for further assistance at 1-844-593-FANS (3267).
Damaged Equipment
Never operate or install any fans or fan accessories that appear to be damaged. Failure to follow this instruction can result in death,
serious injury or equipment damage.
To reduce the risk of personal injury, do not bend the blades or blade holders when installing or cleaning the fan.
Do not insert foreign objects in between rotating fan blades.
Weight and Torque Considerations
Always mount fan directly to building structure that can withstand approximately double (2x) the maximum hanging weight of the fan.
The maximum hanging weight of a 24’ fan with a 4’ downrod is 150 lbs and a maximum torque of 75 ft lbs.
If there is any uncertainty about the potential for the building structure to withstand double the maximum hanging weight of the fan,
a professional structural engineer should perform a thorough evaluation of the building prior to purchasing the fans. Hunter Industrial
provides guidelines for mounting fans; however, it is the sole responsibility of the building owner and installer to ensure the safety of
the mounting system and retention cable, the building structure is sound, and the installation complies with all federal, state, and local
codes.
Mark the Floor to Alert Personnel
When mounting a fan in an area where materials could be elevated and contact the rotating fan blades, mark or
paint the floor with a large crosshatched circle, similar to the figure to the left, to alert personnel of the overhead fan
locations.
BEFORE YOU BEGIN
SAFETY & PRECAUTIONS
!
CRUSH HAZARD