8
45068-01 • 05/19/10 • Hunter Fan Company
You can assemble your fan for
standard
or
angled
mounting as shown
in steps 3-1 – 3-3 .
3-1 . To assemble fan to hang down from a flat or angled ceiling, place
the canopy and canopy trim ring around the adapter so that they
rest on the fan assembly .
3-2 . Feed the wires from the fan through the downrod .
Note:
Make sure all the wires are on the same side of the metal
dowel pin inside the dowrod .
3-3 . Loosen the square head setscrew on the adapter to install the pipe
and ball assembly .
Note:
When the pipe and ball assembly is fully
installed, 2-3 threads on the pipe will still be visible; this is normal .
Securely retighten the setscrew with a wrench or pliers .
CAUTION:
The adapter has a special coating on the threads . Do
not remove this coating; the coating prevents the downrod from
unscrewing . Once assembled, do not remove the downrod .
WARNING:
Do not carry or lift fan by canopy .
3-4 . Raise the fan and place the ball into the hanger bracket .
3-5 . Align the notch on the ball with the indent in the hanger bracket .
(Rotate the fan until you hear the notch pop into place .)
Go to
4 • Wiring the Fan
.
WARNING:
Fan may fall if not assembled as directed in these
installation instructions .
Steps 3-4 – 3-5
Indent
Steps 3-1 – 3-3
Downrod
Canopy
Canopy
Trim
Ring
Setscrew
Adapter
3 • Assembling the Fan for Ceilings 9 Feet or Higher
