7
45068-01 • 05/19/10 • Hunter Fan Company
2-1 . Drill two pilot holes into the wood support structure through the
outermost holes in the outlet box . The pilot holes should be 9/64”
in diameter .
Note:
Your fan comes with four pre-installed neoprene noise
isolators .
2-2 . Thread the lead wires from the outlet box down through the hole
in the middle of the hanger bracket .
2-3 . Align the slotted holes in the hanger bracket with the pilot holes
you drilled in the wood support structure . For proper alignment
use slotted holes directly across from each other . If you are
installing the fan on an
ANGLED
ceiling, be sure to orient the
hanger bracket as shown in Illustration 2-3 (left or right view) .
Note:
The isolators should be flush against the ceiling .
2-4 . Place a flat washer on each of the two 3” screws and pass the
screws through the slotted holes in the hanger bracket into the
pilot holes you drilled .
Tighten the screws into the 9/64” pilot holes; do not use lubricants
on the screws . Do not over tighten .
Flat Washer
3” Screw
Steps 2-2 – 2-4
Hanger
Bracket
Isolator
Step 2-3 (Angled Ceiling Only)
OR
Ceiling Peak
Ceiling Peak
Large
Opening
Large
Opening
LEFT
RIGHT
2 • Installing the Hanger Bracket
