8
Removing the Glass
The glass is held in place by 6 fixing clips, 4
at the top and 2 at the bottom. Slightly
slacken the lower two fixing screws with a
flat blade screwdriver (There is no need to
fully remove the screws). Holding the glass
with one hand, slacken off the top 2 fixing
screws (Diagram 6) until the clips have
moved away from the glass panel. The glass
panel can then be lifted out.
Gas Supply Connections
The appliance is supplied with an 8mm Bundy pipe and an 8mm compression elbow
to allow easy connection to the mains gas supply. This supply gas pipe should
incorporate a gas service isolation tap that is situated within 1 metre of the
application.
Diagram 7 shows the 8mm Bundy
pipe being fitted to the gas inlet on
the valve. The compression joint is
tightened with a 12mm open-ended
spanner.
Diagram 7
Diagram 6
