Hunt Graphics IMAGE 410, Руководство пользователя

Страница: 19 / 29

- 19 -
3
H
FACE MOUNTING
This process is used to cover a substrate with a clear
adhesive coating. Images can then be mounted face
down on a clear substrate.
Preparation:
Set the temperature of the top main roll to 130
°
F-140
°
F
(55
°
C-60
°
C). The bottom main roll is off.
Load your adhesive on the top unwind.
Prepare a leader board with the same thickness as the
board to be coated.
n
Step one – Measure the thickness of the board being
coated and select the corresponding nip setting.
n
Step two – Pull the adhesive from the top unwind and
lay it evenly over the top roller.
n
Step three - Attach the top release liner to the top
wind up station.
n
Step four – Press the footswitch and push the
adhesive into the nip using the leader board. Release
the footswitch when the rear edge of the leader board
is in the roller nip.
n
Step four - Position the board to be coated behind the
leader. When coating more than one board, ensure
that the boards follow each other without any gaps in
between them. You may use the footswitch or the
motor button.
n
Step five - Follow the last board being coated with a
leader board. This allows the final board to clear the
laminating rollers. Stop the motor and raise the top
roller.
Clear Substrate
Adhesive
Release Liner
Step One
Clear Substrate
Face Down Image
Release Liner
Step Two