Hunt Graphics IMAGE 410, Руководство пользователя

Страница: 14 / 29

- 14 -
3
H
UNWIND BRAKES
The output of your film is greatly affected by the unwind
brakes. These are located on the autogrip unwind shafts.
How to set the brakes:
Tighten the knurled nut to compress the spring.
Compressing the spring will increase the film unwind
tension.
ROLLER NIP SETTINGS
When using a substrate for mounting, it is important to
adjust the rollers to create a gap equal to the thickness of
the board being used. This will allow your material to
receive the correct amount of pressure and prevent
damage to the rollers.
How to set the Nip:
n
Step one – Determine the thickness of the board that
you will use for mounting.
n
Step two – Adjust the nip setting by pressing the? ?
buttons on the control panel to the same thickness
measured in step one.
Equivalent Measurements
Inches Metric (mm) Decimal
1/16 2 0.0625
1/8 3 0.125
3/16 5 0.1825
¼ 6 0.25
3/8 10 0.375
½ 13 0.5
¾ 19 0.75
1 25 1.00
Rotate to compress
Direction of compression