Humminbird HDR 610, Инструкция по установке и эксплуатации

Страница: 17 / 44

13
NOTE: If the pivot assembly is snapped closed over the mounting bracket, use a flat head
screwdriver or similar tool to gently pry the a ssembly away from the mounting bracket (see
the illustration
Prying the Assembly Away from the Mounting Bracket ).
4. Align the mounting bracket transducer assembly with
the drilled holes in the transom. With a 5/16" socket
driver, mount the assembly to the transom using the
two #10 - 1" long screws provided (see the illustration
Mounting the Assembly to the Transom ).
NOTE: Make sure that the mounting screws are snug, but do
not fully tighten the mounting screws at this time to allow the
transducer assembly to slide for adjustment purposes.
5. Snap the pivot arm down into place.
6. Adjust the initial angle of the transducer from back to front by rotating the
transducer until the side seam on the transducer is almost parallel with the bottom
of the boat, one click at a time in either direction (see the illustration
Adjusting the
Initial Transducer Angle ).
Adjusting the Initial Transducer Angle
One click too low
Trailing edge
Correctly aligned
(transducer side seam
aligned with boat bottom)
One click too high
Leading edge
Inserting the Pivot Arm Assembly Into
the Mounting Bracket
Prying the Assembly
Away from the
Mounting Bracket
Mounting the Assembly
to the Transom