10
Trolling Motor Mount
Loose Lock Washer
Fully Compressed Lock Washer
Compressing the Lock Washer
3. Install the Shaft Mount
1. Fold the Landscape Mode mount back down using the release buttons.
2.
For installation on a Fortrex trolling motor
, secure the included small rubber
pads to the inside of the shaft mount as shown in the illustration
Shaft Mount
Rubber Pad Placement
. Remove the backing from the pads and press the
adhesive sides firmly into place against the shaft mount.
Shaft Mount Rubber Pad Placement
shaft
mount
rubber pads
Center the
pads here.
For installation on an Ultrex trolling motor
, rubber pads are not needed.
Proceed to Step 3.
Trolling Motor Mount
4. Connect the Landscape Mode mount to the transducer according to your
Recommended or Optional configuration.
The ratchets are keyed to allow for Port or Starboard installation. The ribs on the
Landscape Mode mount ratchet should align with the marks on your transducer.
The ratchets
are keyed.
Connecting the Landscape Mode Mount to the Transducer
5. Secure the Landscape Mode mount to the transducer with one of the included
lock washers and 1/4-28 screws, using the provided hex bit. Hand tighten the
screw until the lock washer is fully compressed (see the illustration
Compressing
the Lock Washer
), and then tighten an additional 1/4 turn.
Hand tighten only!
WARNING!
The screw and lock washer MUST be fully tightened.
Failure to
do so may result in the transducer detaching from the Landscape Mode mount
in the water.
