13
irreparable damage to your device. You can, however, use your S D card in another BrailleNote Touch
and all your data and settings will follow.
Warning: Tampering with your internal S D card or inserting it in another device is not covered under the
device repair warranty and can result in the device needing to be repaired by HumanWare, or the
purchase of a replacement internal storage card.
1.3.8 Bluetooth
The BrailleNote Touch features an internal Bluetooth Interface.
1.3.9 Wi-Fi
The BrailleNote Touch features an internal Wi-Fi B/G/N interface.
2
Setting Up
2.1
Setting Up your System
Press and hold the Power button.
You will feel a quick vibration and will see “Starting KeySoft” on the
Braille display, with a progress representation. After a few minutes for first boot, you will be welcomed
with a language selection screen and an interaction Wizard that will help you get started with your
BrailleNote Touch. The Wizard will help you familiarize yourself with the more common features of your
BrailleNote Touch. Below are a few helpful commands you should memorize that will help you use your
tablet more efficiently. For a thorough list of commands, please refer to the Command Summary located
at the end of this guide.
2.2
Recharging your system
To recharge your system, plug in the micro USB connector of your recharge cable into the micro USB
port located in the rear of the left edge of your BrailleNote Touch. The two small hooks on the micro
USB connector need to be facing down.
If this isn’t already done, plug in the USB connector of your recharge cable into the power adaptor, then
plug the power adaptor into a power outlet.
Alternatively, you can plug your USB connector into a computer, but note that this method of charging is
slower than charging with a power adaptor.
2.2.1 Maximizing operating efficiency
In a working situation where you need your BrailleNote Touch intermittently, you can enter Standby
mode when you are not using your tablet by pressing the Power button. The screen will power off.
You can exit Standby mode by pressing the Power button again.