human care Altair 55200H, Руководство пользователя

Страница: 25 / 84

www.humancaregroup.com 25
ENGLISH
Functions
Emergency stop
In an emergency, the emergency stop can be ac -
tivated by pressing the RED button. To reset the
emergency stop, turn the RED button clockwise.
Emergency lowering
In event of an emergency the emergency
lowering function can be used. Press emergency
lowering button and down button at least 3 se -
conds simultaneously to activate the emergency
lowering. Older lifts (before july 2016) may not
have double key command and delay.
An audio signal indicates that the lift is
lowering. Always ensure that emergency
lowering can be performed as safely as possible
for the client. The emergency lowering button
only works when the lift is switched on and
emergency stop has been deactivated. When
the emergency lowering is active, the end
position switches are inactive. If the button is
pushed until the lift is in its lowest position, the
lift will start to go up again. Always stop at the
lowest position.
The emergency lowering button
must only be used in emergency
situations.
Safety catch
The lift is equipped with a safety catch. This
prevents involuntary falls. If the lift belt is pulled
out too quickly, the safety catch will engage,
thus preventing the fall. Slacken the lift belt to
unlock the catch. With the safety catch enga -
ged, the lever (10) can never be turned, as this
blocks the lowering function of the lift!
Mechanical emergency lowering
During power loss and the hoist is loaded,
user in the hoist, the mechanical emergency
lowering is activated and the hoist is lowering in
a safe and reliable manner.
Overheating
The lift has overheating protection which stops
the motor if it gets too hot. Overheating can
occur if the motor is overloaded or operated
continuously for quite a long time. The lift’s
work cycle (work:pause) is 15:85. Maximum
continuous operation is two minutes. If this is
exceeded, there is a risk of the motor overhea -
ting.
Belt tension guard
The lift is equipped with a belt tension guard
that prevents unintentional discharging of the
lift belt. The lift must be loaded in order to
be able to pull the belt out. This means that
when the lift is lowered to a surface, the lift
belt is only fed out if it is pulled upwards while
the DOWN button on the hand control or the
control panel is held pressed in. The purpose of
this is to pull out enough of the lift belt in order
to be able to hook the lift onto the suspension
hook, or to unhook it.
Two Speeds
When the lift is loaded with less than approx.
40 kg it can be run at two speeds. If the Up
or Down button is pressed for longer than 3
seconds, the lift will run in the faster mode. If
the lift is loaded with more than approx. 40 kg it
will only run in the slower mode.