Now select the light temperature and press the button until the required atmospheric light
level is achieved. Afterwards the light colour for all the lamp groups is changed (even those
not switched on at this point in time).
The atmospheric light previously set is saved when switching off the coloured light control
unit. The memory status remains the same for at least 6 months even after a power cut.
1.3
Dimming a lamp group
Activate the required lamp group as described with one of the buttons
1
to
4
.
Now press the allocated button for short time: the level of brightness alters from maximum to
minimum and vice versa to any level. Reverse direction is interrupted by a short break.
As soon as the button is released the level of brightness last reached is set.
The level of brightness last set is saved when the coloured light control unit is switched off .
The memory status remains the same for at least 6 months even after a power cut.
1.4
Resetting to the delivery status
In their basic setting all the emotion lamps included light up at a 100% cold white level.
As already described, you are able to adjust the lamp groups to diff erent brightness
levels.
If you would like to return lamp groups set to diff erent brightness levels back to the basic
delivery settings at the same time, press the
ON
(
I
) and
OFF
(
O
) buttons simultaneously
for 3 seconds.
All the connected lamp groups shine again at a 100% cold white level.
1.5
Changing the battery
If your coloured light control unit doesn’t function in the described manner
or the integrated red control lamp only lights up weakly, the battery type
CR2032 (lithium 3V)
should be changed.
You require
one
of these batteries. Proceed as follows:
Open the housing of the remote control unit on the rear side by removing
the screw and taking off the rear cover.
Remove the old battery from the battery compartment using a pointed,
non-conductive object.
Now insert the new battery into the battery compartment (check the polarity).
Please be sure
not to press any buttons while inserting!
Close the housing and please screw on the cover fi rmly.
Caution!
Press
all
the buttons on the front side a few times
before
inserting the new
battery. This avoids the risk of a short-circuit.
COLOURED LIGHT CONTROL
Bedienungsanleitung_Farblichtsteuerung_Druck.indd 12
13.10.15 16:08
