2.3.2
Undoing master programming:
Repeat the above procedure to undo the master setting.
Switching off master mode is confirmed by three
short
light signals from the LED lamp.
Note: Master/slave settings are retained even in power cuts.
2.4
Training the coloured light control unit
Before it can be used, the control unit (receiver) of the coloured light control
unit must be trained.
Switch on the lamp by pressing the
ON
button (
I
) on the transmitter for a short time.
Now press both buttons
and
on the transmitter for about 20 seconds at the same
time.
The system confirms activation with a colour sweep from cold white to warm white.
If you want to undo activation. Repaet the procedure, but press buttons 1 and 2.
The system confirms deactivation by blinking.
2.5
Changing the transmission frequency of transmitter and receiver
If the customer notices that other remote controlled units that are not meant to be
addressed react when the coloured light control unit is used, then the transmission
frequency on which the coloured light transmitter and receiver communicate with one
another can be changed.
In all there are 4 transmission frequencies for wireless transmission of coloured light
control signals. The works setting for the hand transmitter is transmission frequency 1.
To alter this to a different transmission frequency proceed as follows:
Important:
For the period of reprogramming, first disconnect from the mains all remote
control receivers whose transmission frequencies are
not
to be altered!
Now press the
and
OFF
(
O
) buttons until the LED control lamp stops blinking.
Release both buttons.
Slow bright blinking begins.
Within 5 seconds, the
OFF
(
O
) button must be pressed until blinking stops.
Release the
OFF
(
O
) button.
Now actual frequency selection begins.
Bedienungsanleitung_Farblichtsteuerung_Druck.indd 15
13.10.15 16:08
