Hughes Network Systems HN9000, Руководство по установке, Страница: 50 / 154

Note: Some error messages are temporary. For example, you may see a message that
says a commissioning activity is halted; then in a short time the activity resumes.
Figure 22: Terminal Initialization Sequence complete
2. In the event that an error condition prevents the commissioning process from completing,
refer to
Table 7: Guidelines for installation troubleshooting on page 40 for troubleshooting
steps you can take.
Successful commissioning ends with the modem rebooting into normal operational mode.
For detailed information about the commissioning process, the Terminal Initialization Sequence
screen, and possible error messages, see
Commissioning and installation reference information
on page 35. There is also a section on installation troubleshooting ( Troubleshooting installation
problems on page 40). Unless you encounter a problem, you should not need this reference or
troubleshooting information, and you can proceed to Activating the HughesNet service on page
51.
Implementation of second IP address
After commissioning has completed, the installer should continue to use the address settings
specified in
Setting the installer laptop IP address and should continue to use the 169.254.0.1
address to access the modem from the installer laptop. However, after the modem is activated
(a subsequent step), the installer cannot use this address to browse the Internet.
After commissioning, using the customer’s browser, you (or the customer) can type
www.systemcontrolcenter.com (or 192.168.0.1 ) to open the System Control Center. To use
192.168.0.1
, DHCP must be enabled on the computer.
Note: You cannot use the address 169.254.0.1 to access the modem from a computer that
has DHCP enabled.
HN9000 Satellite Modem Installation Guide
34
1037576-0001 Revision E
Commissioning the satellite modem Chapter 5