8
9
• If a particular rear wheel pushes down on the pivoting base plate (causing
it to tilt down), the tweak screw on the OPPOSITE side of the T-bar has too
much tension on it.
• When you determine the tweak screw (in the T-bar) that has too much
tension on it, loosen that tweak screw, and tighten the other tweak screw by
an equal amount.
The HUDY Quick-Tweak Station is perfect for quickly checking for tweak of
your car. For complete geometry adjustment, HUDY also offers the All-In-One
Set-up Solution which gives you all the tools necessary to completely set
up the car geometry as well as setting tweak with the HUDY Ultimate Tweak
Station. The HUDY Ultimate Tweak Station integrates with the rest of the set-
up components for a highly-precise and accurate tweak adjustment, allowing
you to perform all set-up adjustments in one session
#109305
Universal Set-up System all 1/10 nitro & electric touring cars
#109405
Universal Set-up System for 1/12 & 1/10 Pan Cars
»
»
• 1/10 Nitro Touring Cars
• 1/10 Electric Touring Cars
• 1/10 Pan Cars
Setting up an RC racecar is necessary to make the car perform well.
Aside from tweak there are numerous other set-up adjustments that can
be made (depending on the type of car) such as camber, caster, toe, ride
height, downstops, and many others. Car setup is a complex matter, as all
adjustments interact. Fine-tuning the set-up will make your car faster and
often easier to drive near its performance limit. This means that all the effort
you put into your car in preparing it and optimizing the setup will pay off in
better results and more satisfaction.
HUDY offers a complete product line of professional set-up equipment for
complete car set-up and adjustment. HUDY is fully dedicated to designing,
developing, and producing the world’s best, smartest, and most professional
set-up equipment and tools. With their long and distinguished history for
coming up with unique ideas and innovations, HUDY is the leader in the RC
tool and set-up industry… there simply is no better.
HUDY SET-UP ACCESSORIES
To correct tweak on a pancar with T-bar rear suspension:
Tweak on a 1/10 and 1/12 pan car with T-bar suspension can ONLY be
adjusted via setscrews on the T-bar.
• The FRONT tires must be placed on the FIXED base plate, and the REAR
tires must be placed on the PIVOTING base plate; tweak cannot be adjusted
if the car is turned opposite to this.
In the RIGHT example below, the REAR RIGHT wheel is pushing down on
the pivoting base plate too much. This means the LEFT tweak screw has too
much tension. LOOSEN the LEFT tweak screw, and TIGHTEN the RIGHT tweak
screw by an equal amount.
Tighten
Tighten
Loosen
Loosen
• 1/12 Electric Touring Cars
• 1/12 Pan Cars
T-BAR
T-BAR
