4
5
ASSEMBLY & ADJUSTMENT
➊
Before you check & correct the tweak of the car, make sure that
you are working on perfectly fl at surface. For best results use the
ultra-fl at HUDY Set-up Board (#108201) and HUDY Set-Up board
decal (#108211).
➌
Install a threaded foot into the bottom of the center axle, near the
end for the pivoting base plate.
➍
Slide the other end of the center axle through the holes in the fi xed
base plate.
➎
Adjust the length of the tweak station to correspond to the car you
are measuring; the length of the car varies between categories.
Fixed Base Plate:
Lay the pivoting base plate along the top of the fi xed
base plate so you can observe the spirit level. Adjust one or both threaded
Center Axle:
Lay the pivoting base plate along the top of the center axle
so you can observe the spirit level. Adjust the threaded foot in the center
axle until the bubble in the spirit level is between the middle lines.
➏
Adjust the tweak station so it is level.
➐
Reattach the pivoting base plate to the end of the center axle; slide
the stepped end of the center axle through the bearings of the
pivoting base plate.
1/12 cars approximately 200mm
1/10 cars approximately 260mm
DETAIL
DETAIL
➋
Install two threaded feet into the bottom of the fi xed base plate.
feet until the bubble in the spirit level is between the middle lines.
