REMEMBER
to turn off the power. Follow
the steps below to hang your fan properly:
Step 1. Remove the decorative canopy
bottom cover from the canopy by turning the
cover counter clockwise. (Fig. 5)
Step 2. Remove the hanger bracket from the
canopy by loosening the two screws on the
bottom of the hanger bracket a half turn from
the screw head and turning the canopy
counter clockwise. (Fig, 5)
Step 3. Pass the 120-volt supply wires
through the center hole in the ceiling hanger
bracket as shown in Fig. 6.
Step 4. Secure the hanger bracket to the
ceiling outlet box with the screws and
washers provided with UL Listed For Fan
Support outlet box.
Step 5. Remove the hitch pin, lock pin and
set screws from the top of the motor
assembly.
Step 6. Route wires exiting from the top of
the fan motor through the coupling cover,
Decorative scroll, canopy cover, canopy and
then through the ball / downrod. (Fig. 7)
NOTE:
Do not install the decorative scroll
and coupling cover if you plan to use the 4"
downrod.
Step 7. Align the holes at the bottom of the
downrod with the holes in the collar on top
of the motor housing (Fig.7). Carefully insert
the hitch pin through the holes in the collar
and downrod. Be careful not to jam the pin
against the wiring inside the downrod. Insert
the locking pin through the hole near the end
of the hitch pin until it snaps into its locked
position. (Fig.7)
Step 8. Tighten two set screws on top of the
fan motor firmly. (Fig. 7)
Step 9. Secure the decorative scroll to the
top of motor housing with the 3 screws.
(Fig. 7)
Step 10. Place the downrod ball into the
hanger bracket socket. (Fig. 8)
5. Hanging the Fan
4
Figure 5
Hanger bracket
Ceiling
canopy
Canopy
cover
Mounting screws
(supplied with
electrical box)
Hook
UL Listed
electrial
box
Figure 6
Figure 7
Figure 8
120V Wires
Washers
Registration slot
Canopy
Set screws
Hitch pin
Lock pin
Canopy cover
Coupling cover
*Omit coupling
cover when using
the minimum-length
downrod
Decorative scroll
*Omit decorative
scroll when using
the minimum-length
downrod
Ball & downrod
Collar
Hanger
bracket
Screws x 3
