7
8. FINISHING THE
INSTALLATION
Step 1. Tuck connections neatly into ceiling
outlet box.
Step 2. Slide the canopy up to ceiling and
over the two screws on hanger bracket.
Rotate canopy clockwise, next, while
holding the canopy with one hand, slide the
canopy cover over the screws and rotate
clockwise until tight.
NOTE:
adjust the
canopy screws as necessary until the canopy
and canopy cover are snug. (Fig.16)
WARNING:
Make sure tab at bottom of
hanger bracket is properly seated in groove of
hanger ball before attaching canopy to
bracket. Failure to properly seat tab in groove
could cause damage to electrical wiring.
7. INSTALLING THE
WALL TRANSMITTER
REMEMBER
to Shut the Power Off at the
Circuit Breaker or Fuse Box.
WARNING:
Hook up in "series only" do
not connect the hot and neutral wires of
electric circuit to the transmitter wall switch
- damage to the switch and possible fire
could occur.
Step 1. Remove the existing wall plate and
switch from the wall junction box.
Step 2. Make the electrical connections as
shown in (Fig. 14). If your outlet box has a
ground wire (green or bare copper) connect
the wall transmitter's ground wire to it;
otherwise connect the wall transmitter's
ground wire directly to one of the screws
from the outlet box.
Step 3. (Fig. 15) Carefully tuck the wire
connections inside the junction box. Secure
the wall transmitter with the two screws
provided. Attach the wall plate over the wall
transmitter and secure with the two screws
provided.
Figure 16
Figure 15
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
