5
6. MAKE THE ELECTRIC
CONNECTIONS
WARNING
: To avoid possible electrical
shock, be sure electricity is turned off at the
main fuse box before wiring.
NOTE:
This remote control unit is equipped
with 16 code combinations to prevent
possible interference from or to other remote
units. The frequency switches on your
receiver and transmitter have been preset at
the factory. Please recheck to make sure the
switches on transmitter and receiver are set
to the same position, any combination of
settings will operate the fan as long as the
transmitter and receiver are set to the same
position.(Fig. 11)
Step 1. (Fig. 12) Insert the receiver into the
mounting bracket with the flat side of the
receiver facing the ceiling.
Figure 11
Figure 9
Figure 10
Figure 12
CHANGING THE DOWNROD
(OPTIONAL)
NOTE:
Your fan comes with a 8" downrod
attached to the hanger ball. In addition you
have been provided with a 4" downrod to
use if desired. If you choose to use the 4"
downrod, perform the following steps:
1. Remove the hanger ball from the 8"
downrod by loosening the set screw at the
top of the downrod which holds the hanger
ball to the downrod. (fig. 10)
2. Slide the hanger ball down the downrod
and remove the support pin. (fig. 10)
3. Insert the support pin in the holes at the
top of the 4" downrod and slide the hanger
ball up the 4" downrod. Make sure the
support pin is properly seated in the grooves
in the top of the hanger ball.
4. Tighten the set screw firmly.
Downrod
Cross pin
Hanger
ball
Set screw
Code switch
ON
ON
Receiver
Transmitter
Receiver
Hanger
bracket
INSTALLATION OF SAFETY
SUPPORT
An additional safety support is provided to
prevent the fan from falling. Secure the
safety cable to the ceiling joist with screw
and washer, as illustrated in Figure 9.
Hanger bracket
Safety cable
