Hubner FGH 8, Инструкция по эксплуатации и сборке

Страница: 15 / 30

Incremental hollow shaft encoder FGH 8
FGH8_MANUAL-en_R6(2018-11-19)ID74584.docx
15
NOTES!
The radial deviation of the shaft ( Fig. 2) should not exceed 0,05 mm.
3.
Use feather keys in accordance with DIN 6885.
4.
Mount the torque bracket / torque arm on the housing.
NOTES!
Comply with the information provided in the supplemental data sheet entitled “Mounting
Accuracy of hollow shaft encoders”.
5.
Check the mounting position relative to the terminal box, adjust if necessary.
6.
Push the device onto the shaft that has been lightly greased.
CAUTION!
Danger of damage to shaft and device if improperly handled.
Ensure that there are no hard impacts on hollow shaft and housing.
Use the mounting sleeve.
7.
Fasten axial tensioning elements. (Screw, axial clamping shoes or flange).
8.
Tighten the fastening screws on the link head of the torque bracket. Fix the nuts in place with
locknuts.
9.
Check the attached torque brackets:
The link rod must be easy to turn within the link head, and the link heads should not tilt. If this
instruction is not followed there is a danger of bearing damage.
10.
Connect the cabling in the terminal box ( Appendix, connecting diagrams).
Mounting / removal sleeves for standard bores
FGH 8..
Drg. no. E-52 443a
FGH 8 / B 14 Drg. no. E-52 760
Only mounting sleeve