50 | 60
OWNERS MANUAL | Cobolt 08-01 Series | D0141-K SEPTEMBER 2020
Once the laser is connected it can be controlled from the box dedicated for the laser. Only the relevant information is
presented on this level, displaying only the status the laser is in and relevant choices to make. Here follows a short
description of how to use the Cobolt Monitor™ software on this level.
Laser successfully connected.
Laser ON
–
Turns the laser ON. If the laser is in autostart mode, this is equiv
alent to “restart”.
Laser OFF
–
Turns the laser OFF.
Mode
–
Gives a choice of operational modes possible to choose for the laser model. For 06 series laser models
Constant Power, Constant Current or Modulation mode operation can be chosen. Only relevant choices for the mode
of operation are presented.
Commands
–
opens a command communications window to send commands directly to the laser.
Message
–
highlights important information of the laser status to the user.
Disconnect
–
allows the user to disconnect from the Cobolt Monitor™ software in a controlled way.
NOTICE
The communication cable should not be removed when the software is in connect state. The
communication within the laser may then malfunction and this might require a power restart of the
driver. To disconnect the laser, click “Disconnect” or close Cobolt Monitor™ completely. It is also
possible to disconnect by powering the laser O
FF. In this case Cobolt Monitor™ will automatically
close the window for that laser.
