HUAYUAN POWERCUT105, Инструкция по эксплуатации

Страница: 30 / 43

- 26 -
6.Optimize cutting quality
Following points can get better cutting quality on cutting vertical, slag and smooth
1
、
Notice for use cutting table and torch
⑴
Check the vertical of the torch
⑵
Clean the rail and transmit device on the cutting table to get smooth torch move. If not
stable will cause cutting roughness
⑶
Cutting torch can;t contact with the workpiece, or it will damage the protection cap and
nozzle, cause cutting surface not smooth.
2
、
Shield gas set
Check carefully according to the”inspection before start”process
Blow the gas hose before cut
3
、
Lengthen the wearing parts life
⑴
Don’t strike torch arc without workpiece
Can strike arc on side of the workpice, but don’t strike without workpiece
The piercing height should be 1.5-2 times distance from torch to workpiece should be
⑵
Make sure the cutting arc is on the workpiece after cutting finish to avoid arc off
⑶
If cutting arc off, try the following:
Lower the cutting speed when cut near finish
Stop cutting when workpiece near finish, the current and gas flow reduce gradually can
finish the cut
Edit the routine for torch run into the waste parts so that can use the current and gas
gradually reduction.
Note: if possible, use the chain cutting method, then the torch can continuous cut along
with the cutting route without stop.but for too long time chain cut will cause
electrode loss
4
、
Other factor influence cutting quality
⑴
Cutting angle
If the four side cutting tilt angle less the 4 degree, that is normal
P10
Monitor
warning function
On
（
1
）
Off
（
0
）
- 0
To on/off the torch
monitoring function
Note 1: long time press “DISPLAY” key 7 seconds, can restore factory setting, the th
e P02~P10 back to default values.
Note 2
：
After warning need shut off the power before replace the consumables