Acceptance Manual
Tecal RH2485 V2 Server
Part II Operation Guide
15
Test Description
T05-04 Configuring RAID 10 Properties by Using the Hard Disk Controller
LSI SAS2208
T05-0401 Configuring RAID 10 Properties by Using the Hard Disk Controller LSI SAS2208
Objective
To verify that you can configure RAID 10 properties by using the hard disk controller
LSI SAS2208
Test Networking
Diagram
None
Preset Conditions
The server is powered on, and the hard disks are detected.
Test Procedures
1.
Press
Ctrl+H
in the POST phase. The window for configuring the LSI SAS2208
is displayed.
2.
Click Configuration Wizard.
3.
In the displayed window, select
New Configuration
and click
Next
.
4.
Click
Yes
when "You have chosen to clear the configuration. This will destroy
all virtual drives. All data on all virtual will be lost. Are you sure you want to clear
the configuration?" is displayed. In the displayed window, select
Manual
Configuration
and click
Next
.
5.
In the
Drives
pane, select two hard disks while holding down
Ctrl
. Click
Add to
Array
to add the hard disks to
Drive Groups
on the right. Click
Accept DG
.
Drive Group 0
is created automatically.
6.
In the
Drives
pane, select two more hard disks while holding down
Ctrl
. Click
Add to Array
to add the hard disks to
Drive Groups
on the right. Click
Accept
DG
.
Drive Group 1
is created automatically. Click
Next
.
7.
In the displayed window, click
Add to SPAN
in the
Array with Free Space
pane. Click
Next
after the two disk groups are added to
SPAN
. In the
Virtual
Drive Definition
window, select
RAID 10
, enter the recommended capacity
(under
Virtual Drives
) in
Select Size
, and retain default settings for other
parameters. Then click
Accept
. Click
Yes
when "Write Through mode
eliminates risk of losing cached data in case of power failure. But it may result
in slower performance. Are you sure you want to select write through mode?" is
displayed.
8.
Click
Next
and
Accept
in the two displayed windows respectively.
9.
Click
Yes
when "Save this configuration?" is displayed.
10.
Select
Yes
when "All data on the new Virtual Drives will be lost, want to
initialize?" is displayed.
11.
Click
Home
.
Spanned Drive Group: 0, RAID
10
is displayed under
Logical
View
on the right, RAID 10 properties are configured successfully.
Expected Result
RAID 10 properties are configured successfully.
Test Description
