Installation Reference
54/55 >>
Powering on the RTN 380H (DC)
Powering On the RTN 380 Supplied by the Outdoor PI
1
Check the system indicator on the RTN 380H.
2
Caution
Caution
Before powering on the equipment, ensure that:
•The P&E cable and the PI power cable are installed.
•DIP switches are set correctly, and the DIP switch for setting the P&E mode for the used P&E
port is turned to the PSE-PD side. After setting the DIP switches, switch off the power supply.
After waiting for 6 seconds, switch on the power supply again.
• Power on the equipment within 24 hours of unpacking.
• During maintenance, the power-off time of the equipment cannot be longer than 24 hours.
Before powering on the RTN 380H, ensure that:
•The DC power cable has been properly installed.
•You are familiar with the safety precautions about DC power supplies.
•The RTN 380H must be powered on within 24 hours after being unpacked.
•The power-off duration of the RTN 380H must not exceed 24 hour during maintenance.
POWER
P&E OUT
Switch on the power supply device connected to the PI.
Connected to a DC power supply device
PWR
1
Turn on the DC power supply device.
Check the system indicator on the RTN 380H.
2
PWR
System indicator
NOTE
In normal conditions, POWER and P&E OUT indicators
are on (green). For a description of indicator states, see
the PI installation guide.
System indicator
NOTE
In normal conditions, the system indicator is
on. For a description of indicator states, see
the
Product Description
.
NOTE
In normal conditions, the system indicator is
on. For a description of indicator states, see
the
Product Description
.
