ME60
Hardware Description
1 Hardware Description
Issue 01 (2018-05-07)
160
Appearance
Panel
Table 1-115
Buttons
Name
Description
OFL
Before removing a board, press and hold the OFL button for about 6
seconds until the OFL indicator turns on. Then, you can remove the
board.
This button takes effect only on the slave MPU.
RESET
When this button is pressed, the board is reset.
USB OFL
Reserved.
Table 1-116
Indicators
Name
Description
OFL (red)
If this indicator is on, you can remove the board.
RUN (green)
Before the board is powered on and registers, this indicator status
changes in the following sequence: off > blinks quickly > steady
on > blinks quickly > steady on > blinks slowly (0.5 Hz).
After the board is powered on and registers, if this indicator blinks at
0.5 Hz, the system is working properly.
ALM (red)
If this indicator is steady on, an alarm is generated.
If this indicator is off, no alarm is generated.
ACT (green)
If this indicator is steady on, the board functions as the master one.
If this indicator is off, the board functions as the slave one.
MGMT-ETH
LINK (green)
If this indicator is steady on, the link is Up.
If this indicator is off, the link is Down.
Содержание ME60 Series
