![background image](http://html.mh-extra.com/html/huawei/isitec-bts3601c-800/isitec-bts3601c-800_user-manual_166557049.webp)
User Manual
iSiteC BTS3601C CDMA Base Station
System Description
Chapter 3 System Function
3-27
l
MTRB statuses include:
Status type
Value range
Enable (enabled)
Disable (disabled)
Degrade
Not Install (not installed)
Operation status
Board Not Config (board not configured)
Block (blocked)
Administration status
Unblock (unblocked)
II. Board special status
l
MBPB special statuses include:
Special status
type
Status name
Value range and description
Work mode
E1 Mode
T1 Mode
E1/T1 line select
Optical Fiber (connected to BTS through MASU optical interface
via E1/T1)
Direct E1/T1 Line (connected to BTS via E1/T1 cable)
E1/T1 impedance
120 ohm
75 ohm
Loop mode
No Loop (normal operation mode)
Local Loop
Remote Loop
Payload Loop
Single Channel Loop
Clk mode
Master (master mode)
Slave (slave mode)
LOS alarm (E1/T1 signal lost alarm)
AIS alarm (E1/T1 alarm indication signal)
LFA (E1/T1 frame lost alarm)
LMFA (E1/T1 multi-frame lost alarm)
RRA (E1/T1 remote alarm)
E1/T1 State
E1/T1 link work state
Ok
Config state
Not Config (not configured)
Config (configured)
Work mode
ATM_UNI (ATM UNI mode)
UNI State
Tx port status
Active (activated)
Inactive (not activated)
Rx port status
Active (activated)
Inactive (not activated)
Port loop mode
No Loop
Serial Loop
Upstream Loop
Downstream Loop
LCD alarm (cell delimitation alarm)
UNI State
UNI link work state
Ok (normal)
Bootp State
SUCCESS (success)
FAILURE (failure)
BTS IP Address
IP address of BTS (available only when BOOTP status is
"success")
Bootp State
OMC IP Address
IP address of OMC (available only when BOOTP status is
"success")
Clock state
Clk ref source
INBRDREF_CLK (board internal clock source)
EXTERNAL_CLK (external clock source)
INTERNAL_CLK (internal clock source)