1
2
3
WPS
RESET
POWER
LAN
1. IP STB
2. WS311
3. Power adapter
The position of the Ethernet interface on an IP STB varies with the IP
STBs produced by different manufacturers. The position of the
Ethernet interface on the IP STB as shown in the preceding figure is
provided only for your reference.
Step 3
Power on the WS311.
After the power adapter connected to the WS311 is supplied with power, the
WS311 is powered on and the power indicator on the panel turns on. Wait for a
moment (less than one minute). When the status indicator turns on, it indicates
that the WS311 is started normally.
Step 4
Press the WPS button of the wireless router. Within two minutes, press and
hold the WPS button of the WS311 for over 2s, and then release it.
At this time, the wireless network indicator of the WS311 blinks in orange,
indicating that the WS311 is trying to connect to the wireless router through the
WPS function. Wait for a moment (generally about 10s and less than 120s).
When the wireless network indicator of the WS311 turns solid orange, it
indicates that the WS311 successfully connects to the wireless router through
the wireless network.
The wireless network indictor keeps on in solid orange for 300s.After
300s, it turns green.
If the wireless network indictor turns off after blinking in orange, it
indicates that the WS311 cannot connect to a wireless network. For the
solution, see section
11
