User Manual
Aolynk DR814Q ADSL2+ Broadband Router
5 Advanced Configuration
49
Figure 5-13
Route configuration
The route list displays details of all active routes on the DR814Q.
You can configure static routes manually. The setting items are listed in Table 5-6.
Table 5-6
Description of static route setting items
Item
Description
Destination
Type in the destination IP address, that is, the IP address of the
termination (target network or host that data to be sent to) for the
static route.
Netmask
Type in the subnet mask, which determines the network address
and host address parts of the IP address.
Gateway
Type in the IP address of the gateway device through which the
DR814Q communicates with the destination network or host.
Interface
Select the service interface that runs this route. The default
option none indicates that no interface is needed.
Cost
Type in the hop count from the DR814Q to the destination.
Advertise
Set whether to advertise (true/false) the route through RIP.
Caution:
For DHCP or Static IP services, you must type in the next hop address in the [Gateway]
filed (you cannot leave it blank), while for the [Interface] drop-down list, you can keep
the default value (none) or select the corresponding interface.
For other services (IPoA, PPPoA, and PPPoE), you can specify a value of either the
interface or the gateway. If both of them are specified, only the interface value takes
effect.
