Huaqi Zhengbang ZB4050LS, Руководство пользователя

Страница: 43 / 45

WenZhou ZhengBang Electronic Equipment Co., Ltd ZB4050LS Rev 1.1
40
7-4 Placement
Example Reason Measure
Place Tomb
1. Solder paste is not sticky enough or over time Replace the solder paste and reprint the PCB
2. Z axis is too fast Reduce Z axis mounting speed
3. Solder paste printing shift Readjust the position of printer
4. Z axis can’t reach the PCB Reset Z axis height distance from PCB
5. Placement time is not enough Increase placement retention time
Overall placement
offset
1. Reference point position is not right Relocate the reference datum point
2. Paste deviation Recalibrate the sticker
3. PCB clamping is not flat Recalibrate the mounting PCB position
4. Mounting speed is too fast Reduce mounting speed
Components Mounted
Inaccurate
1. Suction is different Check and replace the nozzle
2. Feeder coordinates aren’t inaccurate Recheck the position and reset feeder coordinate
Mounting Angle Error
1. Rotate motor damage Replace the rotating motor
2. Nozzle Mismatch Replace larger size nozzle
Sticker doesn’t fit
1. The head switch is off Open the sticker switch
2. Plywood placement is not in the mounted
state
Change to Not mount as placement status
7-5 MARK Point
Example Reason Measure
Can’t catch the
MARK point
1. Recognition range is too small Increase the recognition range
2. Mark point image isn’t updated Update Mark point image
3. The light source is not bright enough Adjust the brightness of the Mark point source
4. Mark point features aren’t obvious Re-find two points defined as Mark points
5. Mark point deviation is too large Transfer guide rail is too wide to adjust the width of the small
guide rail.
7-6 Power Supply
Example Reason Measure
No Power
1. Fuse Damaged Check and replace the fuse
2. Poor connection
Check the tightening plug and check if there is a problem with
the power supply