8
Powerline HDS 230
01/2014
HDS 230
Checking the
fl
ap switch
• Open
the
fl
ap.
The indicator “Flap open” must light up.
The cutting block and conveyor must stop.
After you close the
fl
ap, the display should
go out and you can start the machine again
by pressing the start button.
Inspecting the safety devices
Check that the safety devices
are working properly:
• At the start of each shift
• After any maintenance or repair work
Do not start the machine until you have checked the safe-
ty devices and found them to be in perfect working order.
If any defect arises during operation stop the machine
immediately and make sure it is corrected.
7 Start-up
Switching on the hard drive shredder
• Unlock the emergency stop button
by turning it anticlockwise.
• Turn the main switch to the
I
position.
Caution!
The feed belt can run in reverse if the
phase wires in the power plug are incor-
rectly connected.
Turn off the main switch immediately
and pull out the power plug!
Have an electrician change two of the
three phase wires.
The green “Ready for operation”
LED lights up.
Note:
If the “Ready for operation” display
fl
ashes,
the machine can only be switched on when
the display has stopped
fl
ashing and lights
up continuously.
• Press the start button.
The cutting block and conveyor start up.
Checking the emergency stop button
Press the emergency stop button
while the machine is running.
The shredder must switch off im-
mediately. The cutting block and the
conveyor must stop.
The machine will only start again once
you have pulled out the emergency
stop button again.