HSB Beta 100-D-ZSA, Оригинальное руководство по сборке и обслуживанию

Страница: 26 / 38

Start-up
24
2022-09-01 FM 239 MuW Beta Type Z Rev.01
distributed by
Tightening torque [Nm] of clamping screws
Screw SW Torque
M6 5 14
M8 6 35
M10 8 65
M12 10 74
7 Start-up
Risk of personal injury or damage to other system components
caused by rapid linear motion of the transport carrier,
caused by thrown loads.
Only authorised specialist personnel may start up the linear unit.
Risk of crushing due to incorrect direction of movement of the transport
devices.
Should the direction of rotation of the drive (motor or gear) and the
sliding carriage drive (spindle or toothed belt) not correspond, the
mounted transport devices may travel in the wrong direction. Around all
rotating parts, e.g. GX shaft and around the toothed belt (when used
without cover band), there is a risk of being pulled in, and of clothing or
body parts being caught up and trapped. There is also a risk of
crushing around the moving carriage. These hazards can be countered
by installing effective safety mechanisms that comply with the current
standards and are state-of-the-art. These are not supplied with the
linear unit and must be installed by the manufacturer of the overall
installation.
Use of the deflection belt drive without the protective hood supplied is
not permitted.
Only qualified electricians may carry out the electrical installation and
check the direction of rotation.
Checks before start-
up Before starting the unit, check the following:
•
Make sure the retaining fixtures conform to the mass and
acceleration data provided by the manufacturers.
•
Make sure the machine or line into which the linear unit is installed
conforms to the EU Machinery Directive, the harmonised European
standards or applicable national standards.
•
Make sure the linear unit is correctly installed.
•
Make sure the inductive and/or mechanical limit switches are
correctly connected and working properly.
•
Make sure the direction of rotation of the motor shaft and - where
appropriate - of the interposed gearbox - matches that of the
spindle or timing belt.
If the checks reveal any defects, prohibit start-up of the unit.