HS-Technik HST-MV3-02, Руководство по эксплуатации

Страница: 16 / 32

- 16 -
3 Start-up and use
3.1 Benefits
• Battery parameters are measured and processed
• Special HST frequency modulation impulse charging process® Anti-memory effect
• Automatic voltage detection
• IFCS - Intelligent Full Charge System for Li-Ion batteries
• Capacity-based charge maintenance mode only for Ni-Cd & NI-MH batteries
• Detection of defective cells
• Protection against reverse polarity
• Can also charge at temperatures > 40° C
• Adapter can be changed in 2 minutes
• Software update via USB
• Suitable for Ni-Cd, Ni-MH and Li-Ion batteries
• With PFC (Power Factor Control)
All common battery types from 3.6 - 43.2 V nominal voltage such as Atlas-Copco, Bosch,
Fein, Makita, Panasonic, Desoutter, HS-Technik etc. can be quickly and reliably charged
with the HST-MV3 charging station.
WARNING
The matching battery adapter and the correct software and firmware must
be mounted/installed to charge the batteries.
3.2 Additional information
If the operation voltage is connected and the charging station is switched on, a self test
will automatically start.
After switching on the charger, all of the LEDs will light up and then a signal will sound.
When all of the LEDs go off, the charging station is ready to use. Now batteries can be
inserted for charging.
NOTE
HS-Technik offers updates for the charging station for download in the course
of further development. The operator is obligated to keep the charging station
firmware up-to-date. HS-Technik does not assume any liability for defective
batteries if the charging station is not operated with up-to-date firmware.