HIROSE ELECTRIC CO.,LTD.
ETAD-T0947-00
0
22
/
32
FORM HC0011-9-2
△
3
– Lightly press the panel seal against the chamfer of the panel frontage to position the
male connector.
While in this position, press on the male connector housing or collar and push the male
connector straight into the enclosure opening. Push straight in until the male connector
flange touches the panel.
Pushing the male connector diagonally or pulling the harness side into the enclosure
opening may cause excessive load on the male connector, which may result in damage.
4
– Remove your hand from the male connector. Insert M5 size screws through the two
collars and tighten the screws to a tightening torque of 5.5Nm max to secure the unit to the
panel.
Chamfer of the panel frontage
Chamfer of the panel frontage
Flange
Panel seal
Panel seal
OK: Press both sides
of the collar evenly
NG1: Press the
collar unevenly
NG2: Pull on the
end of the harness
Feb.1.2022 Copyright 2022 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
