HIROSE ELECTRIC CO.,LTD.
ETAD-T0947-00
0
21
/
32
FORM HC0011-9-2
△
8.
ASSEMBLY PROCESS TO THE PANEL
1
– Pick a harness assembly from packaging.
In the harness state, it is recommended to hold the cable and housing. Do not touch the
terminals or the male connector panel seal or retainer. Also, make sure that oil is smeared
over the entire surface of the panel seal. Excessive loss of oil on the surface of the panel
seal will result in insufficient slippage when installed on the panel, causing it to not install
properly and compromising air tightness.
2
– With the orientation of the polarity protrusions on the housing aligned with the
indentations on the enclosure, insert the harness end side through the enclosure opening
until the male connector panel seal touches the enclosure opening.
Housing
(Black or grey)
Cable
Terminal (Inside the
mating part / silver)
Panel seal (Red)
Retainer (White)
Collar (Silver)
Harness tip side
Dimple on top of the panel
Protrusion showing polarity
Casing opening
Feb.1.2022 Copyright 2022 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
